In this fast test you'll be able to pinpoint the problem to the ignition control module or the ignition coil or the Profile Ignition Pickup sensor (PIP sensor) in four easy test steps. This test will only help you in a ‘Cranks but Does Not Start Condition'.
Sound Control (4) / D-Operation Drop: Sound Control (4) / D-Operation Drop - Electrocution Dub (VIP Remix) / Rockin' Da Nation (Soundcontrol Remix) 2 versions: Lion Charge Records: LIONCHG7001: UK: 2015: Sell This Version: 2 versions. Sound Control Technologies manufactures extension kits that deliver Power, Control, IR, Audio and Video over single or dual CAT5e or CAT6 (Solution Dependent) cabling up to 300 feet. Sound Control Technologies' kits support analog and digital high definition PTZ camera solutions for Cisco, Lifesize, Panasonic, Poly, Sony, Avaya and others. We will have 4 speakers throughout with one volume control on the wall. I mean 4 speakers total. Coming into the volume control I'll have the 4 conductor wire and then going out of the volume control I'll have the 2 conductor wire going to 1 of the left speakers and then the 2 conductor wire going to 1 of the right speakers. Sound Control Technologies' Wall Mounts are designed to minimize their appearance, leaving only the camera visible whenever possible. Sound Control Technologies' Rack Shelves are designed to mount two or four SCT RemoteCam™ Head-End and/or Distribution Amplifier modules, and all power supplies. The RemoteCam4™ Project Pack includes.
So then, before starting the tests, it's critical that you have checked and verified that there's NO SPARK present at the ignition coil. Why? Well, because if the ignition coil is sparking, it would be a clear indication that it and the ignition coil and the crankshaft position sensor (PIP sensor) are working.
This article applies to both the Gray colored ignition control module and the Black colored ignition control module. The Gray colored ignition control module is called the Push Start Module and the Black colored ignition control module is called the Computer Controlled Dwell Module. These ignition control modules are not interchangeable.
If you need the tests for the Ford fender mounted ignition control module (ICM), go here: Ford Fender Mounted Ignition Control Module (ICM) Tests. To test Ford Coil-On-Plug Ignition Coils (4.6L and 5.4L V8 engines), go here: Ford Coil-On-Plug (COP) Ignition Coil Tests.
- Where To Buy The Ignition Module And Save.
- TEST INFO: Circuit Descriptions.
- TEST 1: Checking For Power (12 V).
- TEST 2: Testing The Ground Circuit.
- TEST 3 Ignition Coil Switching Signal.
- TEST 4: Testing The PIP Signal.
You can find this tutorial in Spanish here: Cómo Probar El Módulo De Encendido De Ford (Montado En El Distribuidor) (at: autotecnico-online.com).
How Does The Ignition Control Module Work?
Here's a little background information to help you diagnose this no spark condition. In a nutshell, when the system is working properly, at CRANK-UP and at all engine speeds, the ignition control module controls the ignition coil.
How? This is primarily done thru' the Profile Ignition Pickup sensor signal which is received by the ignition control module (and also the ECM).
The ignition control module (ICM) upon receiving this signal, starts switching the ignition coil's ground On and Off. As you may already know, it's this action that makes the ignition coil spark away.
Sound Control 2 4 1986 Vhs
The Profile Ignition Pickup sensor signal (more commonly called the PIP signal) is critical for the ignition control module to start sparking the ignition coil at START UP and at all engine speeds.
The Profile Ignition Pickup sensor is a Hall Effect type crankshaft position sensor and produces a digital (On/Off) signal that can be seen with an LED or an oscilloscope.
On an oscilloscope, it produces a digital square waveform. This sensor is located in the distributor.
What Tools Do I Need For The Ignition Module Test?
There are several ways to test this ignition control module. An oscilloscope is the best way to check all of the input and output signals but it's not the only way. I'll show you just how.
Anyway, if you have access to an oscilloscope, I have included photos of what the waveforms should look like. Whether you use a multimeter or an oscilloscope, you'll be able to successfully diagnose this no-start condition! So, here's the basic list:
- An LED light.
- You can see what this tool looks like here: The LED Light Test Tool And How To Make One.
- Automotive 12 Volt test light.
- Multimeter.
- A cheapie one will do, whether its digital or an analog multimeter.
- If you need to buy one or are looking to upgrade, check out my recommendations here: Buying A Digital Multimeter For Automotive Diagnostic Testing.
- Repair manual.
- This is not an absolute must but you may need it for whatever other information this article does not cover or provide.
- Helper.
- To help you crank the engine while you observe the LED light (or test light or multimeter).
By the way, you don't need an automotive scan tool for any of these tests.
We'll first check for the basics like battery voltage and engine Ground to the ignition control module.
Then we'll test the ignition coil switching signal that the signal generates in action and from the results you get you'll be able to pinpoint the problem to the ignition control module (ICM) or the ignition coil or the Profile Ignition Pickup (PIP) sensor or completely eliminate these as the cause of the no start condition.
IMPORTANT: All of the tests are ON CAR TESTS, do not remove the ignition control module assembly from the vehicle (all of the figures show the module assembly off of the vehicle but this is just for illustration purposes only). Also, the battery must be in a fully charged condition for all tests in this article. And lastly, this Fast Test only tests for a no-spark no-start condition.
Where To Buy The Ignition Module And Save
If you find, after testing the testing the ignition module your test results indicate a bad one then take a look at the links below. I think they'll save you some bucks (especially on the original Motorcraft ignition module):
NOTE: If you're not sure if the above ICM fit your particular Ford don't worry. Once you get to the site, they'll make sure it's the right one, if not, they'll find you the right one.
Do you want to:
- Really impress your friends at the airfield or model boat lake?
- Draw crowds whenever you startup your model airplane, helicopter, boat or tank?
- Win at scale model competitions by wowing the judges with the real sound?
If you answered yes to any of these, then you'll need the ultimate
Our ShockWave® 3 RC Sound Modules are highly advanced and offer a huge feature set and terrific value for money, as well as superb audio performance.
We also have the LARGEST SELECTION of model Airplane, Helicopter and Boatsounds in one place, anywhere on the planet.
We offer a personalized service to our customers, and unlike all other RC model sound system suppliers,we readily entertain building new or customized sound sets to meet your needs.
Our Products
Click on any of the links here to buy any product:
Groundbreaking DopplerFX Technology
Our ShockWave 3 sound module employs Model Sounds Inc. exclusive new technologyin our revolutionary DopplerFX® feature providing enhanced Doppler shift effect. It uses a small GNSS receiver accessory board that provides position and speed informationto the ShockWave 3 sound module. USA GPS, Russian GLONASS, European GALILEO, Chinese BEIDOU andJapanese QZSS satellite constellations are all supported.
The DopplerFX feature enables the model to sound much faster than it is really travellingas it approaches towards and recedes from the operator. Simulated speeds up to Mach 0.5 (617 km/hr or 384mph) are supported.
ShockWave 3 Sound System Exclusive Features
Revolutionary DopplerFX feature, as above.
Unique 'Remote Scroll Through Mode' allowing scrolling up and down available sound sets remotely from your radio to select the sound set you want for your model.
E-Z-SyncTM method of achieving easy push-button synchronization between propeller rotation start/stop and the engine sound startup/shutdown.
The ShockWave 3 sound module also supports 3-position transmitter switches on one radio channel. This is ideal for weapons fire control, e.g. switch up for Machine Gun, switch down for Cannon fire, switch centre is off.
And since 2010, we remain the ONLY RC Sound System Manufacturerto provide two completely independent throttle controlled engine sounds on one sound module!Great for twin engine model airplanes or boats, we can also create custom mixes of two engine sounds per track forfour engined models as well.
The ShockWave 3 sound module is fully programmable and configurable using our ownShockWave 3 PC Windows Software.
118 Airplane Sound Sets Now Available
With the recent addition of our Airbus A380 sound set, we now have an amazing 119 airplane sound sets, in addition to 42 helicopter sound sets, 59 boat sound sets and 13 tank sound sets. This numbers our total pre-configured sound set collection at over 220 and is the largest collection of RC model sounds available in one place on the planet!
The ShockWave 3 sound module is the ONLY RC Airplane Sound Module which includes our huge aircraft sound set collection including many jet and turbo-prop sounds simply not available elsewhere.
We offer the largest jet aircraft sound collection available anywhere, and you get all of them when you purchase our ShockWave 3 sound module or sound systems when it is configured for any airplane sound set.
Quality in Business Certified
As of July 13, 2020, Model Sounds Inc. is 'Quality in Business Certified',an international standard in business quality set by the 'International Trade Council'.
Technical Support
Our sales and technical support is excellent - both pre and post sales supportis always fast and friendly.
Our technical support hours are : Mon. - Thurs. 10:00am - 4:00pm EST/EDT.
Our technical support hours are : Mon. - Thurs. 10:00am - 4:00pm EST/EDT.
Sound Control 2 4 1986 Cutlass
Download our Manuals, Datasheets and firmware upgrades for the ShockWave 3sound module from ourDownloads Page.
